Clutch Cable Adjustment; Throttle Cable Adjustment - Ducati DTL7000 Manual De Instrucciones

English
Owner´s manual
Turn the fuel valve to the OFF position and
remove the fuel strainer cup and the O-ring.
Wash the removed parts in solvent, dry them
thoroughly and reinstall them securely. Turn the
fuel valve ON and check for leaks.
4. Spark plug service
Recommended spark plug: BPR5ES (NGK)
W16EPR, BPR6ES, CTR7F (Groway).
To ensure proper engine operation, the spark
plug must be properly gapped and free of
deposits.
1) Remove the spark plug cap.
WARNING:
If the engine has been running the muffler will
be very hot. Be careful not to touch the muffler.
2) Visually inspect the spark plug. Discard it if
the insulator is cracked or chipped.
3) Measure the plug gap with a feeler gauge.
The gap should be 0.7-0.8mm (0.028-0.031
in),Correct as necessary by bending the side
electrode.
4) Attach the plug washer, thread the plug
by hand to prevent cross-threading.
5) When mounting a new spark plug, you
should screw 1/2 more thread with the wrench
after the washer is compressed. If you are
mounting an old one, you should only screw
1/8-1/4 more thread.
CAUTION: The spark plug must be securely
tightened. An improperly tightened plug
can become very hot and possibly damage
the engine. Never use a spark plug with an
improper heat range.
36

7. CLUTCH CABLE ADJUSTMENT

O-ring
Fuel strainer cup
Measure the free play at the lever tip.
Free play: 3-8mm (0.1-0.3 inch)
If the free play is incorrect, loosen the lock nut
and turn the adjusting bolt near or far as you
need..
After adjustment, tighten the lock nut securely.
Then start the engine and check for proper
clutch lever operation.

8. THROTTLE CABLE ADJUSTMENT

Measure the free play at the lever tip. Free
play: 5-10mm (0.2-0.4 in).
If the free play is incorrect, loosen the lock nut
and turn the adjusting nut near or far as you
need.
in
(1) Lock nut.
(2) Adjusting bolt.
Throttle lever
Adjusting
nut
Lock nut