Belt Tension Adjustment; Transporting /Storage - Ducati DTL7000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. BELT TENSION ADJUSTMENT

Adjust the clutch lever free play
The standard belt tension is 60-65mm (2.4-2.5
inch) at the belt pulley with the clutch engaged
(clutch lever is squeezed). To adjust, loosen
the four engine mounting bolts and the engine
stay tightening bolt, and move the engine
forward or reverse to arrive proper tension of
the belt.
NOTE: After adjusting the tension, make sure
that the outside face of the drive pulley is flush
by using a straight gauge.
(1) Engine mounting bolts
(2) Engine stay tightening bolt
Loosen the attaching bolts of belt stopper.
Adjust the clearance between the belt blocker
and the belt as illustrated with the clutch lever
squeezed.
Owner´s manual
Belt blockers

10. TRANSPORTING /STORAGE

WARNING:
When transporting the tiller, turn the fuel valve
OFF and keep the tiller level to prevent fuel
spillage. Fuel vapor or spilled fuel may be
ignited.
Before storing the unit for an extended period:
1. Be sure the storage area is free of excessive
humidity and dust.
2. Drain the fuel.
WARNING: Gasoline is highly flammable and
explosive under certain conditions. Do not
smoke or allow flames or sparks in the area.
a. With the fuel valve turned OFF, remove and
empty the fuel strainer cup.
b. Turn the fuel valve ON and drain the
gasoline in the fuel tank into a suitable
container.
c. Replace the fuel strainer cup and tighten
securely.
d. Drain the carburetor by loosening the drain
bolt. Drain the gasoline into a suitable
container.
English
37

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido