Section 3: Operation; Site Prep Verification; Controller Lid; Circuit Breaker - Generac 7 kW PowerPact Manual Del Usuario

Ocultar thumbs Ver también para 7 kW PowerPact:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 3: Operation

Site Prep Verification

It is important that the generator is installed in such a way
that the airflow into and out of the generator is not
impeded. Verify that all shrubs or tall grasses have been
removed within 3 ft (0.91 m) of the intake and discharge
louvers on the sides of the enclosure. It is also important
that the generator is not subject to water intrusion. Verify
that all potential sources such as water sprinklers, roof
run-off, rain gutter down spouts and sump pump
discharges are directed away from the generator
enclosure.
WARNING
Risk of fire. Keep air inlet and exhaust areas
free from leaves, grass, snow and other debris.
Failure to do so could result in death, serious injury,
property, and equipment damage.
DANGER
Automatic start-up. Disconnect utility power and
render unit inoperable before working on unit.
Failure to do so will result in death or serious injury.
Turn the generator OFF before performing maintenance.
Remove 7.5 Amp fuse, T1 battery charge fuse, and
disconnect battery cables to prevent accidental start up.
Disconnect
the
NEGATIVE
disconnect the POSITIVE (+) cable. When connecting
the cables, connect the POSITIVE cable first, the
NEGATIVE cable last.
WARNING

Controller Lid

To open or close the controller lid:
1. See view "A" in Figure 3-1. Lift lid from bottom to
open. Lid will lock in place when raised.
2. See view "B" in Figure 3-1. Pull raised lid up and
out sightly to unlock, then lower to close.
Owner's Manual for 7 kW PowerPact™
(000251)
(000191)
(–)
cable
first,
then
(000182)
A
Figure 3-1. Open and Close Controller Lid
NOTE: Local codes may require this compartment to be
locked. A hasp is provided so the owner/operator can
secure the compartment with a padlock (C in Figure 3-1).
Check local codes for side compartment locking
requirements.
NOTE: All appropriate panels must be in place during
any operation of the generator. This includes operation
by
a
servicing
technician
troubleshooting procedures.

Circuit Breaker

The Main Line Circuit Breaker (MLCB) is located under
the Controller Lid. Open the Controller Lid to access the
circuit breaker (A in
Figure
C
A
Figure 3-2. Control Panel and Circuit Breaker
Section 3: Operation
B
C
001038
while
conducting
3-2).
001039
B
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

G0069980Powerpact g0065201

Tabla de contenido