EMAK EF92C/13,5M Manual Del Operador página 62

EN 10
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the protru-
ding shaft (2) with the spokes directed
towards the seat.
Line up the hole in the steering wheel hub
with the hole in the shaft and insert the
pin supplied (3) using a hammer, ensuring
that the end comes completely through to
the opposite side.
NOTE
screw-driver of the same size as the pin when hammering it in the last part.
3.3 FITTING THE SEAT
The seat (1) comes fastened to a support
bracket (2) fitted with the micro-switch (3).
Fit the bracket onto the supports (4) using
the screw bolts (5) supplied and tighten
the nuts (6).
WARNING!
!
from the general wiring (8) to ensure that the safety device works, and
then fasten the wire with the wire-holder (9).
To avoid damaging the steering wheel, use a punch or a
Connect the micro-switch socket (7) to the one coming
UNPACKING AND ASSEMBLY
2
3
7
8
6
5
4
2 3 1
1
9
4