Dismantling And Replacement; Dismantling And Renewing Parts - EMAK EF92C/13,5M Manual Del Operador

EN 44
NOTE
first few times as engagement may be sudden until the belt is sufficiently run in.

6.4 DISMANTLING AND REPLACEMENT

6.4.1 R
EPLACING WHEELS
Stop the machine on a flat surface and put a block under a load-bearing part of
the frame on the side that the wheel is to
be changed.
The wheels are held by a snap ring (1)
which can be eased off with a screwdri-
ver.
The rear wheels are directly coupled to
the differential axle shaft and fastened by
a key that forms part of the wheel's hub.
NOTE
they are of the same diameter, and check that cutting deck is horizontal to pre-
vent an uneven cut.
IMPORTANT
the axle and carefully refit the snap ring (1) and washer (2).
6.4.2 R
EPLACING AND REPAIRING TYRES
The tyres are of the «Tubeless» type and therefore all puncture repairs will have
to be carried out by a tyre-repair expert in accordance with the methods for this
kind of tyre.
When replacing the belt, take great care when using for the
Should you substitute one or both rear wheels, ensure that
Before refitting a wheel, smear some waterproof grease on
MAINTENANCE
2 1