Connecting The Battery - EMAK EF92C/13,5M Manual Del Operador

UNPACKING AND ASSEMBLY

3.4 CONNECTING THE BATTERY

The battery (1) is situated under the seat
and is held in place by a spring (2).
Connect the two red cables (3) to the
positive terminal (+) and the three black
cables (4) to the negative terminal (–)
using the supplied screws and following
the illustrated sequence.
IMPORTANT
the battery according to the instructions
in the battery booklet ( ☛ 6.2.5).
IMPORTANT
ting in, never start the engine until the battery is fully charged!
WARNING!
!
safe handling and disposal.
3.5 FITTING THE GRASS-CATCHER BRACKETS
Fit the two brackets (1) and (2) onto the rear plate in the following order, using the
screws (3) washers (4) and nuts (5) supplied:
Position the screws in the centre of the slots (6) without fully tightening them.
Attach the grass-catcher to the brackets
and make sure that there is an even
distance from 6 to 8 mm between the two
plastic covers.
This allows the grass-catcher to rotate
properly during emptying and prevents
grass from falling out.
To obtain this distance, adjust the faste-
ning position of the brackets in relation to
the slots (6) and finally tighten the screws
(3).
Always fully charge
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
3
4
5
1
4
3
4
6 ÷ 8 mm
EN 11
1 2
6 3
3
2
4
5
4 5
6