Important Safety Warnings; Risk Of Electric Shock Or Electrocution - Mi-T-M HSE Serie Manual Del Operador

WARNING: When using this product, basic precautions should always be observed, including the following.
READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF
ELECTRIC SHOCK
OR ELECTROCUTION
4
SAFETY WARNINGS
POTENTIAL CONSEQUENCE
Serious injury or death could oc-
cur if the pressure washer is not
properly grounded. Your pressure
washer is powered by electricity
and may cause electric shock or
electrocution if not used properly.
Electrical shock may occur from
electrical cord.
Electrical shock may occur if
pressure washer is not operated
properly.
Serious injury or death may occur if
electrical repairs are attempted by
unqualified persons.
PREVENTION
This product must be grounded. Make
sure the pressure washer is equipped with
a GFCI built into the power supply cord. If
this is not available, the pressure washer
must be plugged into a receptacle that is
protected by a GFCI. Disconnect when not
in use.
If your unit is equipped with a GFCI, DO
NOT drop the GFCI as damage could
result. If the GFCI is accidentally dropped,
be certain to test the GFCI before using
to ensure it is working properly. (Follow
instructions on GFCI for test procedures.)
Always be certain the unit is receiving
proper voltage. Before plugging the unit
into a compatible power source, be certain
the switch is in the "OFF" position. Discon-
nect when not in use.
Do not modify plug provided with the prod-
uct. If it will not fit the outlet, have a proper
outlet installed by a qualified electrician. Do
not use any type of adapter.
Check power cord for signs of crushing,
cutting or heat damage. If replacement of
plug or cord is needed, use only identical
replacement parts.
Do not use extension cords with this pres-
sure washer.
Keep all connections dry and off the
ground. Do not allow electrical cords to lay
in water or in such a position where water
could come in contact with them. Do not
touch plug with wet hands.
Do not pull on the electrical cord to discon-
nect from the outlet.
Do not direct spray on or into electrical
installations of any kind! This includes
electrical outlets, light bulbs, fuse boxes,
transformers, the unit itself, etc.
Do not allow metal components of the pres-
sure washer to come in contact with live
electrical components.
Never operate the pressure washer with
safety guards/covers removed or damaged.
Any electrical wiring or repairs performed
on this pressure washer should be done
by Authorized Service Personnel in ac-
cordance with National and Local electrical
codes.
Before opening any electrical enclosure,
always shut off the pressure washer, relieve
pressure and unplug the pressure washer
from the power source. Allow the pressure
washer to cool down. Never assume the
pressure washer is safe to work on just be-
cause it is not operating. It could restart at
any time! Service in a clean, dry, flat area.
Operator's Manual