Quantum TRU BALANCE 3 Instrucciones Básicas De Funcionamiento página 18


Two Post Armrests
The height adjustment range for the Two Post Armrest is 9-13 in.
(22.86-33.02 cm) in 1-in. (2.54-cm) increments. This range is measured
from the top of the seat rail to the top of the armpad. You can also flip
the armrests or remove them for transfer. See figure 11.
To remove the armrest assembly:
1. Push the spring-loaded lever downward and pull up on the front of
the armrest. See figure 11.
2. Remove the detent pin from the back of the seat. See figure 11.
3. Pull up on the rear of the armrest to remove the assembly.
To install the armrest assembly:
1. Set the rear of the armrest into the rear seat receiver and install the
detent pin. See figure 11.
2. Rotate the armrest assembly down.
3. Push the front of the armrest into the front seat receiver and rotate
the spring-loaded lever to the horizontal position to lock into place.
1
Figure 11. Two Post Armrest Removal and Installation
Identification Key
1. Spring-loaded Lever
2. Detent Pin
2