Installation And Use; Cleaning - Quantum TRU BALANCE 3 Instrucciones Básicas De Funcionamiento



Installation and Use

The TRU-Comfort 2 consists of a seatback cushion, lumbar support,
lateral supports, lateral wings, and/or thoracic supports that can be
placed as needed for user comfort and positioning. They are attached
to the seatback with reusable hook and loop fasteners or with hardware.
To place the TRU-Comfort 2 positioning components on the chair:
1. Position the lumbar and thoracic support(s) as needed for user
comfort and positioning flat side down and push onto the seatback.
Position the lateral supports and lateral wings as needed and attach
with hardware. See figure 23.
2. Position the seatback cushion so that the reusable hook and loop
fastener tabs face the seatback. Place the cushion over any lumbar,
lateral, and thoracic support(s) and then secure the cushion to the
seatback using the reusable hook and loop fasteners. See figure 23.
WARNING! Extreme temperatures can affect the temperature
of your cushion components and may cause skin irritation. Use
caution when your power chair has been used or stored in an
extremely hot or cold environment.
WARNING! Ensure all hardware is installed and tightened properly.

Cleaning

The seatback cushion can be easily cleaned.
WARNING! Do not use bleach when washing the outer cover.
Doing so may cause damage to the cover.
WARNING! Follow all safety instructions for the proper use of
the disinfectant and/or cleaning agent before applying it to your
product. Failure to comply may result in skin irritation or premature
deterioration of upholstery and/or power chair finishes.
To clean the seatback cushion cover:
1. Remove the seatback cushion from the seatback by detaching the
reusable hook and loop fasteners that secure the cushion to the
seatback and then pulling the cushion toward you. See figure 23.
2. Locate the zipper at the bottom of the cushion.
3. Unzip the cover and pull out the cushion.
4. Wash the cover in a washing machine at or below a temperature of
158°F (70°C).
5. Allow the cover to air dry.