Controller Position - Quantum TRU BALANCE 3 Instrucciones Básicas De Funcionamiento



Controller Position

You can position the controller for either left-hand or right-hand use. You
can also adjust the extension of the controller from the armrest and the
height of the controller.
WARNING! Use correct tie-down points for controller harness to
prevent the harness from getting caught in the drive tires, pinched
in the seat frame, or damaged when passing through doorways.
To change the controller position:
1. Turn off the power to the controller.
2. Remove the controller harness from the clips securing it to the
armrest.
3. Loosen the mounting screws in the controller mounting block. See
figure 18.
4. Move the controller mounting block and controller to the other
armrest, tighten the mounting screws, and ensure the release lever
is secure.
To change the controller extension:
1. Turn off the power to the controller.
2. Remove the controller harness from the clips securing it to the
armrest.
3. Flip and then rotate the release lever to loosen the clamp. See
figure 19 or 20.
4. Slide the controller into or out of the armrest to the desired position.
5. Rotate and flip the release lever to tighten the clamp.
6. Route the controller harness to the back of the power base and
secure it with clips. See figure 21.
To change the controller height:
1. Turn off the power to the controller.
2. Remove the controller harness from the clips securing it to the
armrest.
3. Flip and then rotate the release lever to loosen the clamp. See
figure 19 or 20.
4. Adjust the controller to the desired height.
5. Rotate and flip the release lever to tighten the clamp.
6. Route the controller harness to the back of the power base and
secure it with clips. See figure 21.