Test Cycle - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

Operation
Cycle Execution
As the cycle proceeds, the display will show
the function being executed, the step number,
and the cycle number selected. Pressing the
Edit Cycle key while the cycle is running will
cause the display to show the remaining cycle
time in minutes. Pressing this key again will
return the display to normal.
To begin the cycle at any step other than the
first step, press the Advance key to advance
through the cycle to the desired starting point.
(The Advance key is enabled at the factory
and can be disabled at the laundry site.) Then
press the Start key.
It is possible to skip to the next step in a cycle,
with the exception of a drain step: Drain steps
must be allowed time to complete.
When the display shows the step desired to
begin the cycle, press the Start key.
If the door is not locked, the display will
indicate "CLOSE" and "DOOR." If this
occurs, be sure the door is closed and locked
and press the Start key again.
If the LED indicator lights for the computer
outputs indicate that one or more outputs are
activated but the washer-extractor is not
functioning according to the output or outputs
indicated, contact a service technician.
20
(Continued)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
As water fills the washer-extractor, one or
more of the indicator lights located to the left
of the keyboard will come on and stay on until
the required water level is reached. LED dots
located in the upper left corner of the last three
digits on the right of the display will illuminate
to indicate the water level(s) reached:
• When the indicator dot in the last digit on
the right is lit, the low water level has
been reached.
• When the dot in the next-to-the-last digit
is lit, medium water level (optional) has
been reached.
• When the dot over the third digit from
the right has been lit, high level has
been reached.
The cycle will continue until its completion.
Then the display will read "DONE."

Test Cycle

Cycle number 01 is a test cycle used to
analyze washer-extractor functions. See the
Programming section of this manual.
Step 01 in cycle number 01 is a cold fill to low
level. This step is designed to give not quite
enough time to complete a fill, causing the
display to read "FILL." Press the Start key
to continue the fill, and the test cycle
will proceed.
F232089