Temperature Display; Error Recovery Routine - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

Note: The computer cannot advance through a
drain step, nor will the computer allow starting
a cycle in a spray rinse or spin step.
Note: A drain step must be programmed prior
to a high speed step to allow for inverter drive
balance detection. Otherwise, spin steps will
be skipped by the computer.

Temperature Display

The temperature display can be prompted to
display in Fahrenheit or Centigrade. See
Prompting the WE-6 in the Programming
section of this manual.
To display temperature, press the Display
Temp key. The display will read "F" or "C"
and the temperature as long as the key is
pressed. The computer will update the
display automatically.
F232089 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Error Recovery Routine

When the computer detects an error, it will
stop running the current step and display a
message to indicate what type of error
was found:
• "FILL" indicates that the washer-extractor
did not fill within the allotted time.
• "EMTY" indicates that the washer-
extractor did not drain in the allotted time.
• "TEMP" indicates that the temperature
sensor has recognized a temperature above
the programmed value.
• "MEMR" indicates that the computer
has detected a problem with the cycle
information. The cycle must be edited.
• "WATER" indicates that the WE-6
computer senses low, medium, or high
water level at the end of the stop routine.
• "DRTEMP" indicates that the WE-6 has
detected water temperature over 160°F in a
"drain to reuse" step. Instead of draining to
a tank, the computer gives this error
message. The cycle must be edited so the
temperature is below 160°F upon entering
a reuse drain step ("Da" or "Db").
All outputs remain off while the message
displays, and the door cannot be unlocked.
Note: The WE-6 computer will not allow
the door to be opened while there is water in
the washer-extractor.
Operation
23