Programming A Spin Step; Programming A Spray Rinse Step - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

Programming
Step Programming

Programming a Spin Step

1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press the Medium Speed or High Speed
key. The High Speed key must be pressed
once for high speed spin No. 1, twice for
high speed spin No. 2, and three times for
high speed spin No. 3. The display will
read "MSnncc" for medium speed or
"H1nncc" for high speed spin No. 1,
"H2nncc" for high speed spin No. 2, or
"H3nncc" for high speed spin No. 3.
(If the High Speed key is pressed when
the display shows "H3nncc," the computer
will then return to "H1nncc.")
3. Press the Enter key. The display will read
"M---S." Now assign time in minutes and
seconds to the spin step.
4. Press the Enter key. The display will read
"SDLY" for one second. The display will
then change to "0M-00S."
5. Now assign the time for the spin delay
(coast down). A minimum of 30 seconds is
recommended.
Note: Do not program a Wash 1 step for a
shakeout after the spin step. If such a step is
programmed, the computer will revert to the
previous wash step and will fill with water
accordingly. See Stop Routine. However, a
Wash 1, 2, or 3 step, programmed for ONE
second will select stop routine agitation and
avoid refilling.
50
(Continued)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Note: Do not program a "SDLY" time of
more than "OM-DOS" if followed by
consecutive spins. This will cause the
computer to skip all consecutive spins and start
on the next non-spin step.

Programming a Spray Rinse Step

When the Rinse key is pressed on the keypad,
the drain will remain open and the basket
will rotate in medium spin speed. Water is
added through the door spray nozzle only.
To program a spray rinse step, use the
following procedure:
1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press a water temperature key (Cold, Hot,
or Warm). If the Cold key is pressed, for
example, the display will read "C-nncc,"
etc. Then press the Rinse key. The display
will read "CRnncc," "HRnncc," or
"WRnncc," depending on whether cold,
hot, or warm temperature was selected.
3. Press the Enter key. The display will read
"M---S." Now assign the time in minutes
and seconds desired for the duration of the
rinse step.
4. Press the Enter key and go to the next step
in the cycle.
Note: If a coast-down delay ("SDLY")
is desired after a spray rinse step, program a
medium-speed spin step for one second after
the rinse step. Then program the desired coast-
down time.
F232089