IMPORTANT SAFETY INSTRUCTIONS
WARNING
– To guard against injury, basic safety precautions should be observed, including the following.
READ AND FOLLOW ALL SAFETY
a)
INSTRUCTIONS.
DANGER
b )
– To avoid possible electric shock, special care should be taken since water is employed
in the use of aquarium equipment. For each of the following situations, do not attempt repairs by yourself;
return the appliance to an authorized service facility for service or discard the appliance.
1 ) If the appliance falls into the water,
components of the appliance get wet, unplug the appliance immediately. (Non-immersible equipment only)
2 ) If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power
source. (Immersible equipment only)
3 ) Carefully examine the appliance after installation. It should not be plugged in if there is water on parts
not intended to be wet.
4 ) Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or has been
dropped or damaged in any manner.
5 ) To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium stand and
tank to one side of a wall-mounted receptacle to
prevent water from dripping onto the receptacle or
plug. A "drip loop", shown in the figure below,
should be arranged by the user for each cord
connecting an aquarium appliance to a receptacle.
The "drip loop" is that part of the cord below the
level of the receptacle, or the connector if an exten-
sion cord is used, to prevent water traveling along
the cord and coming in contact with the receptacle.
If the plug or socket does get wet,
the cord. Disconnect the fuse or circuit breaker that
supplies power to the appliance. Then unplug and
examine for presence of water in the receptacle.
c )
Close supervision is necessary when any appli-
ance is used by or near children.
d )
To avoid injury, do not contact moving parts or hot
parts such as heaters, reflectors, lamp bulbs, and the like.
e )
Always unplug an appliance from an outlet when not in use, before putting on or taking off parts, and
before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
f )
Do not use an appliance for other than intended use. The use of attachments not recommended or sold
by the appliance manufacturer may cause an unsafe condition.
g )
Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezing.
h )
Make sure an appliance mounted on a tank is securely installed before operating it.
i )
Read and observe all the important notices on the appliance.
j )
If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less am-
peres or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that
it will not be tripped over or pulled.
k )
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will
fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully in-
serted. Do not attempt to defeat this safety feature.
Exception: This instruction may be omitted for an appliance that is not provided with a polarized attach-
ment plug.
"SAVE THESE INSTRUCTIONS".
l )
DON'T
reach for it ! First unplug it and then retrieve it. If electrical
DON'T
unplug
USA