Installing The Switch Housing; Installing The Light Kit And Glass - Kichler Lydra 52 Manual De Instrucciones

INSTALLING THE SWITCH HOUSING

Step 1. Remove the screw marked with a dot label which is preinstalled
on mounting plate and keep for later use. Loosen the other two (do
Mounting
not remove). Place the two slot holes on the switch housing over the 2
Plate
screws previously loosened from the mounting plate. Rotate the switch
housing until it locks in place at the narrow end of the key holes. Secure
by tightening the 2 screws previously loosened and the one previously
Switch
removed. (Fig. 20) Housing
Screw

INSTALLING THE LIGHT KIT AND GLASS

Fig. 20
NOTE: Before continuing installation, confirm that the power is still
turned off at the main circuit breaker or by removing the circuit fuse.
Turning the power off using the wall switch is not sufficient to prevent
electrical shock.
Step 1. Hold the light kit close to the switch housing and connect the
WHITE wires from the light kit and fan by pushing the connectors
Switch
Housing
together. Follow the same procedure with the BLACK wires. (Fig. 21)
Light Kit
Step 2. Tuck the connections neatly into the light kit. Remove one of the
three screws pre-installed on the switch housing and keep for later use.
Loosen the other 2 screws (do not remove). Place the two slot holes
on the light kit over the 2 screws previously loosened from the switch
Screw
housing. Rotate the light kit until it locks in place at the narrow end of the
key holes. Secure by tightening the 2 screws previously loosened and
Fig. 21
the one previously removed. (Fig. 21)
52" Lydra LED | 13