Publicidad
Swing Beam Hardware
1. Flip 4'' x 4'' Swing Beam over so that the opposite side of your drilled holes are facing upwards.
2. Place one (1) Wood Loc Washer on each Carriage Bolt with tangs facing downward.
3. With a hammer tap bolts through drill holes in Swing Beam until Tangs sink fully into the wood as shown in
(Fig. 13).
Fig. 13
4-1/2'' CARRIAGE BOLTS
FOR SWING HANGERS
4'' CARRIAGE BOLTS
FOR A-FRAME
WOOD LOC
WASHER
23
ssembly Plan
Publicidad
