Drive Configuration Using The Fe Connect App - Franklin Electric SubDrive 50 Manual Del Usaurio

COMMUNICATIONS
FE Connect Mobile Application

Drive Configuration Using the FE Connect App

The Setup page of the FE Connect App is divided into sub-categories:
1. Pump and Motor Settings
2. Pressure Control
3. Underload
4. Duplex Alternator
5. Advanced Options
6. Available Firmware
IMPORTANT: If using the app to control basic settings, DIP SW1 Position 1 (FE Connect switch) must be—
and remain—in the ON (up) position. Otherwise, the drive will default to the settings made through the DIP
switches and rotary knobs on the drive itself.
Pump and Motor Settings
Enter the required settings based on the pump and motor nameplate information. Refer to
ration" on page 24 for detailed information.
The FE Connect App adds additional settings for more precise motor control:
Motor Poles: Select either a 2- or 4-Pole motor (surface applications).
Motor Overload Current: Set the exact current rating of the motor, which will override the DIP switch pre-
sets (surface applications).
Minimum and Maximum Output Frequency: Set an exact frequency range for more precise control than the
DIP switch presets.
Pressure Control
Sensor Type: This parameter sets which type of pressure sensor is being used.
• Switch – Use this setting when connecting to a standard pressure sensor.
• Transducer (PSI) – Use this setting for a 4-20mA pressure transducer scaled to psi.
• Transducer (bar) – Use this setting for a 4-20mA pressure transducer scaled to bar.
Transducer Range: When using a pressure transducer, this parameter sets the range of the transducer con-
nected to the drive.
• 100 to 300 psi
• Default = 100 psi
32
"Drive Configu-