Winch Operating Principles - DRAGON WINCH MAVERICK DWM 13000 HD Manual Del Usuario

repairing the rope
Repairing of a damaged rope consists in shortening it abo-
ve the damaged place and terminating it with a thimble.
g) Load
Loads must be pulled in a straight line. If pulling loads at
an angle is necessary, use the appropriate load block. In
this case, the angle between the winch drum and the rope
should be 90 degrees.
H) battery
The battery must be efficient, charged and of adequate
capacity [Ah].
Use rubber gloves and goggles when handling the battery.
When operating the winch, the vehicle engine should be
running.

WiNcH operAtiNg priNcipLes

engaged gear. Do not disengage and engage the gear while
the winch motor is running.
4. To avoid damaging the rope, do not install hooks directly
on the rope. It is necessary to use the factory-provided
thimble (eye) or pulley block with a movable pulley.
5. Observe the winch carefully during operation, while
maintaining the maximum possible distance. It is recom-
mended that the pulling process is stopped every meter to
check if the rope is wound correctly.
www.dragonwinch.com
1. Remote control of the winch
should be stored in the vehicle.
2. Check the remote control tech-
nical condition before each con-
nection.
3. The winch is equipped with
a manual gear engaging and re-
leasing. Begin load winding with
gb