Putting Into Operation Controller And Remote Control - FIOR & GENTZ NEURO TRONIC Manual De Instrucciones

Ocultar thumbs Ver también para NEURO TRONIC:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 81
On a controller with exchangeable batteries are four cable joints, which are
marked with numbers from 1 to 4 (fig. 27). On a controller with integrated
lithium-polymer battery, the numbers can be found on the cable connecting
aid (fig. 28). Connect the cables as follows:
Cable Joint
3 and 4
1 and 2
In order to connect the cables to the controller, proceed as follows:
1 Strip the cables of the solenoid about 50mm (fig. 29-30).
2 Strip the exposed wires about 5mm (fig. 31).
3 Twist and tin the exposed conductors.
4 Insert the wires into the corresponding cable joints. For a bilateral treat-
ment, connect the second solenoid to the same cable joints.
When making the cable connection, the polarity of the connec-
tion cables is irrelevant.
5 On a controller with exchangeable batteries, secure the wires by
tightening the respective screws. On a controller with integrated
lithium-polymer battery, use the cable connecting aid to open the cable
conduits for the flexible wires to be inserted. The wires are automatically
clamped by removing the cable connecting aid.
6 Carry out the cable connection test (see manual Multi-Purpose Device).
11. Putting into Operation Controller and Remote
Control
With the multi-purpose device, you put the controller and the remote control without Bluetooth into oper-
ation and establish a connection between the remote control and the controller (see manual Multi-Purpose
Device).
A remote control with Bluetooth can be directly connected to a controller with Bluetooth.
1
Press the MODE button at the controller. First, a short beep is emitted. Keep the button pressed until a
second, longer beep is emitted after about 6-10 seconds.
2 Press the Auto and Lock button of the remote control at the same time for about four seconds. The LED
blinks yellow.
If the connection to the controller has been successfully established, the LED at the remote control blinks
green. If establishing the connection has failed, it blinks red.
A remote control with Bluetooth can also be connected to two controllers with Bluetooth.
34
Cable
solenoid connection cable
pressure sensor connection cable (if existing)
fig. 28
fig. 29
fig. 30
fig. 31

Publicidad

Tabla de contenido
loading

Tabla de contenido