Polini XP 65 R Manual De Uso Y Mantenimiento página 16

4
7- Tighten the spindle locking bolt with a torque wrench
(See section 6.2) (photo 5).
8- Inflate the front and rear tyres (See section 4.12).
9- Fit the front mudguard with the provided 4 screws and
the TBM6X16 washers (photo 6).
10- Cut the transport tie securing the front brake master
cylinder. Fit the handlebar and fix it to the top fork with
the two handlebar clamps and the four Allen bolts
M8X75 (See section 6.2) (photo 7).
11- Regulate the front fork height as per photo No. 8
(see section 6.2 for tightening torque)
ATTENTION! For safety reasons the front fork must be
extracted within notch No. 4 (minimum) and No. 5
(maximum) (photo No. 8).
ENGLISH
4
5
12- Remove the throttle control cover and fit the cable as
shown in photo 9. Re-fit the cover. (See section 4.9).
6
13- Fit the front brake lever and secure the clamp with the
provided screws
14- Fit the engine stop button and fix it to the handlebar
with its mounting clamp
15- Fit the clutch lever and adjust the travel of the lever as
you prefer using the regulator (photo 10) (See section
4.11). Fit the number plate fixing it with the related
spacers and screw TBEI M6X40 and insert the front
brake cable in the slide.
16- Fit the footrests (photo 11)
17- Fill the engine coolant circuit
(See sections 4.5 and 4.6) (photo 12).
ATTENTION! While filling the cooling system,
open the draining screw on the left radiator till
the liquid comes out.
7
8
MINIMUM 4 NOTCHES
MAXIMUM 5 NOTCHES
9