Adjusting Top Tether; Remove And Install Harness - BQS BVO FIX 0123 Manual De Uso

4. PREPARATORY WORKS
4.6.1 ISOFIX INSTALLATION
1. On both sides of the seat squeeze the ISOFIX button and pull out ISOFIX
connectors in longest position (fig. 18, 19).
18
20
21
22
30
19
2. Slide the two ISOFIX connectors
firmly into the insert guides until
the ISOFIX connectors engage
with a clicking noise on both sides.
The ISOFIX button must turn green
on both sides (fig. 20, 21).
CAUTION
The ISOFIX connectors are only
correctly engaged if both of the
ISOFIX buttons are green.
3. Push the child seat towards the
backrest applying firm, even
pressure on both sides. Shake
the child safety seat to make
sure it is safely attached and re-
check the green safety buttons to
make sure that both of them are
completely green (fig. 22).
4. PREPARATORY WORKS
4.6.2 REMOVE ISOFIX
Push the child seat
towards the backrest
applying firm (fig 23).
At the same time squeeze
ISOFIX button and pull
back ISOFIX connectors
(fig. 24).

4.7 ADJUSTING TOP TETHER

1. Take the top tether and if required, lengthen the belt by pressing the top tether
brake button to release the strap, pulling to adjust as necessary (fig 25).
25
26
2. Attach the top tether hook to the top tether anchorage point which is recommended
in the owner's manual of your car (fig. 26)
Look for this symbol in your vehicle.
3. To tension the top tether, remove any slack by pulling on the free end of strap until
it is suitably tightened. The top tether will be properly tightened when the tension
indicator turns completely green (fig. 27).

4.8 REMOVE AND INSTALL HARNESS

28
23 24
27
1. Unhook the shoulder
29
belts on the back side
of the child seat from the
yoke.(fig. 28).
2. Store the yoke in the bag
of fabric cover. (fig. 29).
31