BQS BVO FIX 0123 Manual De Uso página 18

5. INSTALLATION
3. Pull the diagonal belt strongly to tighten (hold
tension) and clamp the lock-off device on
diagonal belt as close to vehicle seat belt buckle
as possible (fig. 43).
4. Seat back then through upper belt guide which in
the same side of vehicle seat belt retractor. (fig.
44).
CAUTION
Make sure belt is not twisted and buckle is
engaged.
5. Shake the child safety seat to make sure it firmly
installed in the vehicle. (fig. 45).
6 . Have your child sit down in the child seat. Adjust
headrest in proper height (see section 4.3), adjust
harness and lock buckle (see section 4.1), and
tighten harness. (see section 4.2) (fig. 46).
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK:
- The child seat is firmly installed in the vehicle;
- The straps of the child safety seat are close to
the body without constricting the child.
- The shoulder belts are correctly adjusted and
the straps are not twisted.
- The shoulder pads are at the same level as
your child's shoulders.
- The buckle latches are engaged in the
harness buckle .
5.2 GROUP 1 FORWARD FACING
(9-18kg) approx. from 9 months to 3 years
IMPORTANT
DO NOT use forward facing before the child's
weight exceeds 9 kg.
1. Rotate seat to forward facing (see section 4.5).
Place seat in the direction facing to the travel. (fig.
47, 48).
34
5. INSTALLATION
2. Install ISOFIX connectors
(see section 4.6) (fig.
43 43
49) (If your seat don't
equipped
your car don't equipped
ISOFIX
1
please install only use
3-point belt).
2
3. Pull
out and guide it pass
through the belt pass slot
of the child seat. (fig. 50)
44 44
Make sure that the belt is
not twisted.
4. Engage
tongue in the vehicle
seat buckle this should
make a click noise. (fig.
51)
CAUTION
The vehicle seat belt
45
buckle must not be
positioned in the belt
pass slot.
5. Pull the diagonal belt
strongly to tighten (hold
tension)
the lock-off device on
diagonal belt as close to
vehicle seat belt buckle
46
as possible (fig. 52).
CAUTION
Make sure belt is not
twisted and buckle is
engaged.
6. Shake the child safety
seat to make sure it
firmly installed in the
vehicle. (fig. 53).
ISOFIX or
anchorage,
the Vehicle belt
the buckle
and clamp
47 48
49 50
51 52
53
35