Installation - BQS BVO FIX 0123 Manual De Uso

4. PREPARATORY WORKS
3. Unhook the shoulder
pad straps from the
connecting piece (fig.30).
4. Pull out both the
shoulder pads and the
two shoulder belts from
the slots (fig.31).
5. Open buckle (fig.32).
6. Roll the shoulder belts
together and store them
in the bag of fabric cover
(fig. 33).
7. Grasp the metal plate
from underneath and
turn it into a vertical
position. Push upwards
and slide the metal plate
through the slot (fig.34).
8. Re-fitting the harness:
Simply follow the steps
in the opposite order.
Make sure the belt is not
twisted.

5. INSTALLATION

5.1 GROUP 0+ REARWARD
FACING
(0-13 kg) approx. from
born to 12 months
WARNING
DO NOT place rear-
facing child seat on
front seat with active
airbag, DEATH OR
SERIOUS INJURY can
occur.
1. Rotate seat to rearward
2. Place seat in the direction facing opposite to the
facing (see section 4.5), adjust
seat in most reclined position
TIP:
(see section 4.4).
32
30
32
32
34
36 37
travel (fig.35, 36, 37).
Infant cushion is for child below 9 kg.
5. INSTALLATION
31
31 5.1.1 INSTALL USING ISOFIX CONNECTORS AND
TOP TETHER
(If your seat don't equipped ISOFIX or your car don't
equipped ISOFIX anchorage, please see section 5.1.2
Install use 3-point belt).
1. Install ISOFIX connectors (see section 4.6) (fig. 38).
2. Guide top tether along both sides,then attach top
tether hook to anchorage point. (see section 4.7)
(fig. 39).
3. Have your child sit down in the child seat. Adjust
33
headrest in proper height (see section 4.3), adjust
harness and lock buckle (see section 4.1), and
tighten harness. (see section 4.2) (fig. 40)
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK :
- The child safety seat is engaged on both sides
with the ISOFIX connectors in the ISOFIX.
- Attachment points and that both buttons are
35
green.
- The child seat is firmly installed in the vehicle.
- The Top Tether is tightly tensioned over the
backrest of the car seat and the tension.
- Indicator is green.
- The straps of the child safety seat are close to
the body without constricting the child.
- The shoulder belts are correctly adjusted and
the straps are not twisted.
- The shoulder pads are at the same level as
your child´s shoulders.
- The buckle latches are engaged in the harness
buckle.
5.1.2 INSTALL USE 3-POINT BELT
1. Open buckle then remove infant cushion (fig. 41).
2. Guide vehicle lap belt through both lower belt
guides, engage the buckle tongue in the vehicle
seat belt buckle. (fig. 42) Put infant cushion back.
CAUTION
The vehicle seat belt buckle must not be
positioned in the lower belt guide.
38
CLICK
39
40
41
42
33