BQS BVO FIX 0123 Manual De Uso página 19

5. INSTALLATION
7. Have your child sit down in the child seat. Adjust
headrest in proper height (see section 4.3), adjust
harness and lock buckle (see section 4.1), and
tighten harness. (see section 4.2) (fig. 54)
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK:
- The child safety seat is engaged on both
sides with the ISOFIX connectors in the ISOFIX
attachment points and that both buttons are
green.
- The child seat is firmly installed in the vehicle.
- The straps of the child safety seat are close to
the body without constricting the child.
- The shoulder belts are correctly adjusted and
the straps are not twisted.
- The shoulder pads are at the same level as
your child' s shoulders.
- The buckle latches are engaged in the harness
buckle.
For Group 1 installation, this seat also can use vehicle
belt only, it has been tested and homologated also.
If you wantonly use vehicle belt installation, just skip
the ISOFIX connector relative content.
5.3 GROUP 2/3 FORWARD FACING
(15-36kg) approx. from 4 years to 12 years
1. Remove the harness when use as group 3, see
section 4.8.
2. Rotate seat to forward facing (see section 4.5).
Place seat in thedirection facing to the travel. (fig.
55, 56).
3. Install ISOFIX connectors, see section 4.6 (fig.57)
(If your seat don't equipped ISOFIX or your car
don't equipped ISOFIX anchorage, please install
only use 3-point belt).
4. Have your child sit down in the child seat. Adjust
headrest in proper height (see section 4.3). Pull out
the vehicle seat belt and guide it in front of your
child to the vehicle seat buckle. Engage the buckle
tongue in the vehicle seat buckle (fig. 58).
36
5. INSTALLATION
54 CAUTION
The vehicle seat belt buckle must not be
positioned in the lower belt guide.
5. Place the diagonal seat belt section and lap belt
section on the side of the vehicle seat belt buckle
in the lower belt guide. (fig. 59).
6. Place the lap belt section on the other side of the
childseat in the lower belt guide.(fig. 60).
CAUTION
The lap belt section must lie as low as possible
over your child's hips on both sides
7. Guide the diagonal seat belt section into the belt
and is not twisted. (fig. 61)
55
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK:
- The child safety seat is engaged on both
sides with the ISOFIX connectors in the ISOFIX
attachment points and that both buttons are
green.
- The child safety seat is engaged on both
sides with the ISOFIX connectors in the ISOFIX
56
attachment points and that both buttons are
green.
- The child seat is firmly installed in the vehicle;
- The lap belt section runs through the lower
belt guides on both sides.
- The diagonal seat belt section on the side of
the vehicle seat belt buckle also runs through
the lower belt guide.
- The diagonal seat belt section runs through
57
the belt holder of the headrest.
- The buckle is engaged, belt is not twisted.
WARNING! For Group 2 and 3 installation, this seat
also can use vehicle belt only, it has been tested and
homologated also. If you want only use vehicle belt
installation, just skip the ISOFIX connector relative
content.
58
59
60
61
37