Product Care; Removing The Seat Cover - CYBEX JUNO-FIX Guia Del Usuario

PRODUCT CARE

To guarantee that your child seat provides the maximum protection, it is essential

to comply with the following points:

All visible parts of the child seat must be regularly checked for damage. The

mechanical parts must function faultlessly.

It is essential to make sure that the child seat is not jammed between hard

parts such as the car door, seat rails etc., which can damage it.

If the child seat is dropped it must be tested by the manufacturer before being

used again.

CLEANING

Care must be taken that only an Original CYBEX Seat Cover is used, because

the cover is also a fundamental component of the good functioning of the child

seat. Replacement covers may be obtained from a specialist shop.

NOTE! PLEASE WASH THE COVER BEFORE USING IT FOR THE FIRST

TIME. THE COVER SHOULD BE WASHED AT 30 °C IN A DELICATE

WASH CYCLE. WASHING IT AT TEMPERATURES HIGHER THAN 30 °C

MAY RESULT IN THE COLOURS RUNNING. WASH SEPARATELY FROM

OTHER ITEMS AND NEVER DRY IN THE TUMBLE DRYER! NEVER DRY IN

STRONG SUNLIGHT! THE PLASTIC PARTS CAN BE CLEANED WITH A MILD

CLEANING AGENT.

Warning! Never use chemical cleaning or bleaching agents!

The cover consists of three main components for headrest, backrest and seat

cushion, which are secured to the child seat either by velcro, press-studs or

elastic bands. Once you have released all the fastenings, you can remove the

individual components for washing.

To detach the individual components of the cover carry out the following steps:

Once the press-studs on the back of the backrest have been undone, the

cover can be removed by drawing it forwards.

To remove the seat cushion cover, release both belt straps and also undo the

press-studs on the underside and draw the cover forward.

The headrest cover can simply be pulled forward to remove it.

To replace the cover, carry out the same steps in the reverse order.

Tabla de Contenido