Switching On The First Time; Suggestions - Franke COUNTRY FLAT CF 55 M /F Serie Manual De Instalación Y Servicio

The hands will then return to their original
„ „
position to indicate the current time: when the
set time is reached, the ringer sounds. This
sound can be stopped by pressing the knob.
The timer does not control oven heating.
„ „
End of cooking
To set the end of cooking time, press the knob
X X
twice (the LED for the
flash); then turn the knob to move the hands in
order to set the end of cooking time.
The LED will blink for the next 10 seconds (for
„ „
possible adjustments), after which the setting
will be acquired and the LED becomes steady.
The same effect is obtained by pressing the
„ „
knob twice during blinking. At the end of
cooking, oven heating will be deactivated and
the ringer will sound for 1 minute; this sound
can be stopped by pressing the knob.
Note: At the end of cooking, the oven remains at
a temperature close to the previously set value for
several minutes; it is therefore wise to remove the
food from inside so as to avoid overcooking it.
End of cooking with delayed start
Delayed start of cooking can only be activated
X X
following the end of a cooking process; when set,
pressing the knob confirms the „stop", and
activates the blinking LED for the symbol
Turn the knob to also set the start of cooking time
X X
(naturally this will be before the end, therefore the
hands can only be moved back).
Confirm by pressing the knob again.
X X
The data can also be automatically acquired by
X X
allowing the blinking to continue for 10 seconds.
The LEDs for symbols
„ „
remain lit and the oven will switch on at the set
time, when only the LED for the symbol
will remain lit.
At the end of cooking, the ringer will sound
„ „
for 1 minute; this sound can be stopped by
pressing the knob.
Setting the time of day
To set the correct time, just press the knob
X X
three times (the LED for the clock symbol starts
blinking), then turn the knob.
After setting the right time, press the knob to
X X
confirm.
CF 55 M _/F
symbol begins to
.
and will
– 9 –

Switching on the first time

When using the oven for the first time, operate it
X X
empty with the temperature knob set to maximum
for at least 40 minutes, keeping the door
completely closed and airing the room.
The odour noticed during this operation is
„ „
due to the evaporation of substances used to
protect the oven during the period between
manufacture and installation.
After the 40 minutes, the oven stops
„ „
automatically and will be ready for use after
cooling down the oven.

Suggestions

For successful cooking, never place your dishes in
Z X
the oven when it is cold; wait until it has reached
the set temperature.
During cooking, never place pots or containers
Z X
directly on the oven floor;
9 place them above the grills or drip-trays provided,
on one of the 5 shelves available;
Failure to do so could damage the oven
„ „
enamel.
Never cover the walls of the oven with aluminium
Z X
foil, especially in the lower part of the cooking
compartment.
Any repairs must be carried out by specialised,
Z X
licensed personnel. Contact our nearest service
centre and demand only original spare parts.
Your Franke oven uses a special enamel which
Z X
is easy to keep clean, however it is advisable to
clean it frequently to avoid baking on grime and
previous cooking residues.
Any self-cleaning panels (if provided) can be
Z X
cleaned with soap and water (see cleaning
instructions).
EN