SEA Bleu B100 Manual Del Usuario página 14

English
TRANSMITTERS' CODE SETTING
Press the "LEARN BUTTON", the "LEARN LED" turns on, then press the chosen button on the transmitter until the "LEARN LED"
flashes and turns off, now the transmitter is encoded. Other transmitters may be encoded in this way, up to a maximum of 20.
DELETE TRANSMITTERS
To delete transmitters codes press the "LEARN BUTTON" and hold until the "LEARN LED" turns off (after 10 seconds). Now, all
learned transmitters codes have been deleted.
Working logic without automatic closing: OPEN-STOP-CLOSE-STOP-OPEN.
Working logic with automatic closing: in opening OPENS until the end of the run, in closing OPENS again until the end of the
run.
USER GUIDE
Pay attention when using
1. Before performing the first normal operation after installation, please make sure that the door is in good working conditions.
Open the door manually.
2. The door and operator need regular maintenance to ensure their proper operation :
- Check the open and close limit positions.
- Check and adjust the balance spring if needed.
- Check and adjust the working force if needed.
- Check the moving parts of the door construction and lubricate as needed.
In case of power failure use the release to open the door manually.
IMPORTANT USER SAFETY INSTRUCTIONS
1. The operator must not be activated unless the garage door is in the full view of the user and free from persons, objects or cars.
2. Enter or exit the garage only when the door has completed its movement.
3. Keep the remote controls out of reach of children and never allow them to activate the operator.
4. Regularly check and test the working force. Malfunctions, improper settings or wrong operations can cause serious injuries to
persons or property damages.
5. Do not release when persons or objects are in the doorway.
14 67411340 REV 06 - 06/2014