Switching The Burners Off; Relighting The Burners; Checking The Flames - Barbecook STELLA 4311 Guia Del Usuario

9. 3 .2 U
SING A MATCH
1 Place a match in the match holder.
2 Open the lid and set the control knob of the infra-red
burner to OFF.
3 If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4 Light the match and hold it to the left of the infra-red burner.
5 Set the control knob of the infra-red burner to HIGH.
6 If the burner does not light within 5 seconds, set its control
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
7 Retry lighting the infra-red burner. If it still does not light, refer
to "14 Troubleshooting" to determine the cause of the problem.

9.4 Switching the burners off

If you no longer use the burners, you have to switch them off.
Proceed as follows:
1 Close the gas supply.
2 Set the control knobs of the burners to OFF.
By closing the gas supply first, you make sure there is no
2
gas left in the appliance.

9.5 Relighting the burners

If a burner goes out while in use, proceed as follows:
1 Open the lid and close the gas supply.
2 Set all control knobs to OFF and wait 5 minutes. This allows
any accumulated gas to escape.
3 Relight the burner(s).
12

9.6 Checking the flames

Each time you light a burner, you have to check its flames. A
perfect flame is almost completely blue, with some yellow at the
top. Sporadic yellow flames are normal and not harmful.
If there is something wrong with the flames, do one of the
following to solve the problem:
If the flames are...
Low and entirely yellow
Higher than the bowl
www.barbecook.com
Do the following...
1 Immediately close the gas supply and
set all control knobs to OFF.
2 Refer to "14 Troubleshooting" to
determine the cause of the problem.
Most likely, the venturis are blocked.
1 Immediately close the gas supply and
set all control knobs to OFF.
2 Wait 5 minutes to allow any
accumulated gas to escape.
3 Relight the burner(s).
4 If the problem persists, refer to
"14 Troubleshooting" to determine
the cause of the problem.
LOW HIGH