The following list of tools will be needed for proper installation of all components:
• Safety Glasses
• 15/16" Open End Wrench (5/8" HEX NUT)
• 1-1/8" Box End Wrench (3/4" HEX HEAD BOLTS & NUTS)
• 15/16" Socket (5/8" HEX HEAD BOLT)
• 3/4" Socket (1/2" HEX NUTS)
• Measuring Tape
• Torque Wrench capable of 380 ft-lbs of torque
Recommended tools for installing the Hitch Ball:
None are required as the hitch ball comes from the factory pre-installed. It is recommended that you
check the tightness of the hitch ball nut periodically using a 1-1/2" or 1-7/8" Thin walled socket depending
on hitch ball size.
Torque Wrench capable of 360 ft-lbs of torque (always check ball manufacturer's specifications for
proper torque rating)
Definitions of terms: When a statement like "LEFT SIDE or RIGHT SIDE OF VEHICLE" is made, this
always refers to the driver's point of view, in other words, when the driver is sitting in the driver's seat of
the vehicle. Other terms used are DS which means DRIVERS SIDE and PS which means PASSENGER
SIDE; this is regardless of where you are positioned inside or outside of the vehicle.
Before installing or towing with this Bolt Together Weight Distributing Hitch please read and
follow all instructions and warnings in the tow vehicle owners manual and trailer owners manual.
Have gross trailer weight and tongue weight checked before selecting and installing any weight
Weigh trailer again after fully loaded and check loaded tongue and gross weight to ensure proper
This kit is to ONLY be used with Husky weight distribution spring bars only that are
designed for this particular system. Do not substitute with any other spring bars.
Do not use a separate friction sway control on this unit!
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty
Information / Tech Support / Product Updates. ©2017 DTS Mfg. All Rights Reserved. April 30, 2018-Rev8
Tools Required for Installation
Important!
distributing system.
weight distribution hitch is being used.
CAUTION!
Warning!
Page
4