Husky 32215 Montaje, Instalación, Operación Y Mantenimiento Instrucciones página 8

6. Align the bottom hole on the channel to the hole on the shank and insert a 3/4" hex head bolt.
Remember the hole and orientation in these instructions are an example only, yours may be
different.
7. Add hardened washers marked with "F436" on to the large head pin, and then insert into the welded
bushing on the inside top of the channel. Start with 2 hardened washers if trailer frame is 4" or 5". Use
3 hardened washers if the trailer frame is 6", 7" or 8"
2 or 3 Hardened washers and large head pin.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty
Information / Tech Support / Product Updates. ©2017 DTS Mfg. All Rights Reserved. April 30, 2018-Rev8
Place a 3/4" ID washer onto
the 3/4" hex bolt first.
8
Page