Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Measure the Tow Vehicle
For vehicles with air springs, air shocks or automatic leveling systems only: Check vehicle owners
manual or other instructions on these items. Unless otherwise indicated, air springs and air shocks
should be deflated to their minimum recommended pressure BEFORE assembling and adjusting the
weight distribution hitch. Pick reference points at the top center of the front and rear fender well of
towing vehicle. Measure and record the height to pavement here:
FRONT FENDER TO PAVEMENT:
REAR FENDER TO PAVEMENT:
ILLUSTRATION 3
Installation and Setup
NOTE: To obtain proper ball height on low ground clearance tow vehicles, shank may be oriented in the
"UP POSTION" as shown in Illustration 4. If shank is used in the "DOWN POSITION, check shank for
adequate ground clearance. Accessory shanks with greater height and length are available from your
dealer. IMPORTANT! Proper adjustment requires the use of the proper length shank; proper head
height and proper head tilt adjustment.
ILLUSTRATION 4
Up (Upright)
Down (Inverted)
Position
Position
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty
Information / Tech Support / Product Updates. ©2017 DTS Mfg. All Rights Reserved. April 30, 2018-Rev8
6
Page
Publicidad
Tabla de contenido
