Measuring Dc Current - KPS -PA60 Manual De Funcionamiento

KPS-PA60 • Digital clamp meter
• Connect the common test lead first and then the charged test leads
when making connection. Take away the charged test lead first when
disconnecting.a.
4.9 Measuring AC Current
Beware of Electrocution.Ensure that the test leads are disconnected
from the meter before making current clamp measurements.
• Set the rotary selector to the A range position.
• Push the REL key make sure the LCD display zero if the unsteady reading
appear before measurement.
• Press the trigger to open jaw. Fully enclose only one conductor.
• Take the reading on the LCD.
NOTE:
1) Do not put more than one cable into the jaw during test, otherwise incorrect
test value might be obtained.
2) For optimum results, center the conductor in the jaw.
3) At the manual range mode, when only „OL‟ is shown on the LCD, it means
the measurement has exceeded the range. A higher range should be selected.
4) If the scale of the value to be measured is unknown beforehand, set the
range to the highest.
4) Si la escala del valor a medir no se conoce con antelación, seleccione la
escala más alta.
5) " " means the maximum input current is 1000A rms AC.

4.10 Measuring DC Current

• Set the rotary selector to the A range position.
• Press the FUNC key turn to DC current measurement mode..
• Press the "REL" button, the meter will be set to zero.
• Press the trigger to open jaw. Fully enclose only one conductor.
• Take the reading on the LCD.
• Symbol "-" will be displayed on LCD if the direction of the current is negative.
NOTE:
1) Do not put more than one cable into the jaw during test, otherwise incorrect
WARNING
39