Connection Of The Water Massage Circuit; Connection Of Air Massage Circuit - Iberspa INGROUND SPAS Manual De Instalación Y Usuario

Inground Spa Manual EN
3.3.1.2 SPA with SKIMMER:
Connection Spa – Compact Kit (See Fig. 5)
Connect the skimmer outlet with the heat exchanger inlet.
Connect the Spa floor drain with the filtration pump inlet in parallel to the rest of the inlets.
Connect the filtration pump outlet to the filter's selector valve (depending on the kit model, this
connection may already be made).
Connect the selector valve outlet to the water inlet of the heat exchanger (depending on the kit
model, this connection may already be made).
If your Spa has the ozone option, follow the instructions indicated in the Ozonator installation
sheet now.
For the selector valve connections, always use plastic accessories, gasket and Teflon tape.
Under no circumstance should you use metal accessories or tubing, which could seriously
damage the plastic components.
Connection Compact Kit– Spa (See Fig. 5)
Connect the heat exchanger outlet with the Spa's filter return nozzles, placing a check valve in
this connection.

3.3.2. Connection of the Water Massage Circuit

(See Fig. 8). Connect the pipe to the water suction drains with the inlet to the massage pump
(each pump will suction the water of 2 drains).
Connect the outlet of each of the massage pumps to the connections in the Spa battery that will
guide the water to the jets.
Place a ball or guillotine valve in the inlet and outlet of each pump.

3.3.3. Connection of Air Massage Circuit

(See Fig. 9). Leave the air pump inlet free and connect the pump outlet to the Spa's
corresponding connection.
Note: It is essential to install a 150mm siphon above the maximum water level and to place a
check valve between the siphon and the Spa.
Fig. 25 Diagram of installation of air circuit siphon.
25