Maintenance In Periods Of No Use Or Absence - Iberspa INGROUND SPAS Manual De Instalación Y Usuario

Inground Spa Manual
It is essential to ensure that the projector is perfectly watertight; otherwise, water could
enter the device and could harm the bulb or LED.
WARNING:
Before handling the spotlight in any way, ensure that it is NOT connected to the power
supply.
The new bulb must have the same features as that supplied with the spotlight:
- For halogen lamps: 50W 12V AC halogen with aluminised reflector.
- For LED lamps: 11W RGB, 15W white, 12V AC.
Under no circumstance should you install lamps without a frontal lens.
In order to ensure watertightness, you must clean the seat of the flush joint of the fitted
glass or replace it if it shows any dents or permanent deformation.

4.3. MAINTENANCE IN PERIODS OF NO USE OR ABSENCE

SHORT PERIODS (3-5 DAYS)
Adjust the pH and treat the water (see section on water Maintenance)
Cover the Spa
On your return, readjust the pH and treat the water again.
LONG PERIODS (5-14 DAYS)
Program the temperature at its lowest level.
Adjust the pH and treat the water (see section on water Maintenance).
Cover the Spa
On your return, reset the temperature to the desired level, readjust the pH and treat the
water again.
PREPARING FOR THE WINTER PERIOD
Should you not be using the Spa during the winter or during long periods, you must carry out
the following operations:
Disconnect the electrical equipment.
Empty the water from the Spa.
Leave the drain valve open.
Clean and dry the Spa.
Cover the Spa.
You should not leave water in the Spa without an electrical connection outdoors in
temperatures below 0ºC, given that the pipes could freeze and damage the Spa.
It is necessary to comply with Regulations in force in each country regarding Legionella.
All responsibility for compliance with these falls on the owner of the Spa.
29
EN