Maintenance; Maintenance Of The Acrylic; Maintenance Of The Spotlight - Iberspa INGROUND SPAS Manual De Instalación Y Usuario

Inground Spa Manual

4. MAINTENANCE

Spas are built to the highest standards with the most durable materials available. The right
maintenance and care will be key factors to ensure your Spa and its components have a long
life.

4.1. MAINTENANCE OF THE ACRYLIC

Easy care for an elegant surface:
Use common cleaners for general use. For normal care and cleaning, use a soft cloth or
sponge with a little soap and water. Rinse it well, and dry with a clean, dry cloth. If you
are using a household cleaner, please ensure it is recommended for acrylic surfaces by
the manufacturer.
Never use abrasive cleaners
Do not allow the acrylic surface to come into contact with ketones or esters such as
acetone, acetates (such as nail varnish remover, nail varnish or dry cleaning
substances) or any organic solvent with chlorine, varnishes, petrol, aromatic solvents,
etc.
Remove dust, smears and dry dirt with a soft, moist cloth.
Clean off grease, oil, paint and ink stains with isopropyl alcohol and dry it with a clean,
dry cloth.
Avoid using razors or any other kind of sharp instrument that could scratch the surface.
Small scratches can be removed by applying a fine layer of automotive varnish and
lightly polishing it with a clean cloth.
Once a week, clean the area of the Spa which is not under water with a quality polish for Spas.
Remember to never leave the Spa uncovered, empty and exposed to the sun, as it could
cause damages that the warranty does not cover.

4.2. MAINTENANCE OF THE SPOTLIGHT

(Only for Spas with this option).
The only maintenance needed by the spotlight is changing the bulb. To change it, follow these
steps:
Ensure that the main circuit breaker is on the OFF position.
Empty the water from the Spa.
Unscrew the spotlight cover (see figure) and then proceed to extract its transparent screen.
This operation must be made with the white ABS tool supplied with this manual.
Carefully extract the bulb or LEDs of the reflector and separate from the holder.
Change the bulb and proceed to assembling the spotlight following the above steps
backwards.
Turn left and extract
28
EN