Standard Accessories; Optional Accessories; General Conditions Of Use - Corghi EM 9550 Plus Manual De Uso

................................................ from 1 to 500 mm
max. wheel width (with guard)................560 mm
max. wheel diameter (with guard)..........1118mm
maximum wheel weight.................................75 kg
Machine weight (without accessories)......140 kg
Operating noise level.............................<70 dB(A)

STANDARD ACCESSORIES

The following parts are supplied together with
the machine.
Weight pliers
Calliper for wheel width measurement
Sliding flange holder kit
Calibration weight
Wheel balancer power supply cable
Monitor power supply cable
Kit 4 cones
Wheel fixing cap guard
Wheel spacer
Wheel fixing cap
C VERSION
C hub
C locking device
C hub key
STD VERSION
Threaded hub
Hexagon wrench, size 10
Wheel fixing quick ring nut

OPTIONAL ACCESSORIES

Please refer to relevant accessories catalogue.
GENERAL CONDITIONS
OF USE
The equipment is intended for professional
use only.
WARNING
Only one operator at a time can work with the
machine.
The wheel balancers described in this manual
must be used exclusively to measure the extent
and position of car wheel unbalances, within the
EM 9550 Plus - EM 9550 C Plus - Operator's manual
limits specified in the Technical specification
section. Furthermore, models equipped with
motors must be provided with a suitable guard,
fitted with a safety device, which must be lowered
during the spin operation.
WARNING
Any use of the machine other than the de-
scribed use is to be considered as improper
and unreasonable.
CAUTION
Do not start the machine without the wheel
locking equipment.
WARNING
Do not use the machine without the guard and
do not tamper with the safety device.
CAUTION
Do not clean or wash the wheels mounted on the
machine with compressed air or jets of water.
WARNING
When working, never use equipment not manu-
factured by the manufacturer.
WARNING
Get to know your machine: The best way to
prevent accidents and obtain top performance
from the machine is to ensure that all operators
know how the machine works.
Learn the function and location of all the controls.
Carefully check that all controls on the machine
are working properly.
To prevent accidents and personal injury, all the
equipment must be correctly installed, correctly
operated and correctly serviced.
POSITION OF THE OPERATOR
Figure 12a shows the positions occupied by the
operator during the various work phases:
A Mounting / disassembling operations, launch,
UK
51