Corghi EM 9550 Plus Manual De Uso página 62

The laser line remains visible within the rim for
10 seconds then, if necessary, press the lever
button again.
- Return the measuring arm to the rest position.
Automatically the machine will setup in the ALUP
balancing programmes (FSP programme).
- Perform a spin
- at the end of the spin, if you want to change the
balancing programme set automatically by the
machine (FSP), select the
the required programme is selected.
Balancing weight application
- Select the plane where the first balancing weight
is to be applied.
- Turn the wheel until the central element of the
corresponding position indicator lights up.
If the weight to be applied is a conventional
clip type(inner side in Alu 2P), apply it on the
corresponding 12 o'clock position. If instead
the type of weight to apply is adhesive and the
CLP mode was selected (see the " Selection of
Adhesive Weight Application Position" section):
- Position it inside the cavity of the weight-holder
terminal of the measuring arm (fig.25,a,b), with
the backing paper of the adhesive strip facing
up. Then remove the guard (fig.25c).
a
b
d
-
Move the sensor until it reaches the signalled
position. During this phase, the unbalance
value of the side to be balanced is shown on
one display, whereas the numerical value up-
dated according to the sensor position, which
62
- Turn the end of the measuring arm until the
- Press the button (fig.25d) to eject the weight
- Return the measuring arm to the rest position
- Repeat the operations to apply the second
button until
If the weight to apply is adhesive and H.12 mode
was selected, apply it on both planes in the posi-
tion corresponding to 12 o'clock.
If the weight to apply is adhesive and the LAS
mode was selected, apply the weight in cor-
respondence of the laser line in the position in
which the respective plane was acquired.
- Perform a test wheel spin to check the balancing
The rim surface must be perfectly clean to make
the weight stick efficiently to the rim. If neces-
sary, clean the surface using suitable cleansing
products.
This function is automatically enabled when an
ALU P programme is selected.
The function modifies the positions selected for
c
the application of adhesive weights, to ensure
perfect wheel balancing using commercially
available adhesive weights (in multiples of five
grams). The accuracy of the machine is thereby
improved, avoiding rounding off or cutting the
weights to be applied to come closer to the actual
unbalance values.
The modified positions, where the adhesive
weights are to be applied, are identified by the
user according to the information given by the
wheel balancer (see the BALANCING WEIGHT
e
APPLICATION section).
25
This programme divides the outer weight Pe into
EM 9550 Plus - EM 9550 C Plus - Operator's manual
becomes zero when the position for applica-
tion of the weight is reached, is shown on the
other display.
weight adhesive strip is in line with the rim
surface.
and make it stick to the rim.
(fig.25e).
balancing weight.
accuracy.
"Movable planes" programme
(available only with ALU P pro-
grammes)
"Hidden Weight" programme
(available only with ALU P
programmes)