Maintenance Procedures - MSA 360S Guia Del Propietario

DOFFING THE HELMET
Unbuckle the chinstrap. Then while
holding the helmet, turn the ratchet
knob counter-clockwise to loosen the
headband and remove helmet.

MAINTENANCE PROCEDURES

Cleaning
• Clean the helmet after each use,
but before inspection using the
procedures described.
• NEVER use a helmet that is wet
from use or cleaning. Allow all
parts to dry before use.
• Remove from service any helmet
that has been exposed to chemical
or biological contaminants.
Consult MSA for decontamination
or disposal procedures.
Clean helmet before inspection fol-
lowing the specified procedures.
Failure to follow these cleaning pro-
cedures may reduce helmet per-
formance and result in serious per-
sonal injury, disease, or death.
Faceshield or Goggles
To clean the faceshield or goggles,
use mild cleaning agents such as ethyl
alcohol or a mild detergent and water,
and a soft sponge or cloth. NEVER
use abrasives, solvents paint
removers, acetone, paint or lacquer
thinner, or any chlorinated organic sol-
vents. Removal of light scratching and
smoke stains to faceshields can be
achieved through the use of MSA
MAINTENANCE
WARNING
CairnsHELMETS Scratch Remover &
Polish (# R1).
Bourkes [Models 880, 1000, 1010,
1044, N5A, N6A]:
To clean BOURKES, use a mild deter-
gent and water, and a soft sponge or
cloth. NEVER use abrasives, solvents
paint removers, acetone, paint thinner,
lacquer thinner, or any chlorinated
organic solvents. Removal of light
scratching and smoke stains to
bourkes can be achieved through the
use of MSA CairnsHELMETS Scratch
Remover & Polish (# R1).
Helmet Shell – Remove
faceshield/goggle/bourkes before
cleaning
1. Thermoplastic Shell [Models 360S,
660 Phoenix, and 880]:
a. To clean, use mild cleaning
agents such as ethyl alcohol or a
mild detergent and water, and a
soft sponge or cloth. NEVER use
abrasives, solvents paint
removers, acetone, paint or lac-
quer thinner, or any chlorinated
organic solvents. Removal of
light scratching and smoke
stains to thermo-plastic helmets
can be achieved through the use
of MSA CairnsHELMETS Scratch
Remover & Polish (# R1).
2. Fiberglass/Kevlar Composite Shell
[Models 660C Metro, 660CE, 664,
990, 990E, 1000, 1010, 1044, HP3,
515, 515E]:
a. To clean, use only mild solvents,
such as ethyl alcohol, mild
detergents and water, mild abra-
sives, industrial cleaners (such
as DuPont
tone, or paint remover.
9
® Tar Remover), ace-
TAL 4011 (L) Rev. 9 - 10043529