Connecting Your Kube - Kinetico Water Systems kube14 Manual Del Usuario

4

Connecting Your Kube

1
Check Clearance
Clean out the area under your sink,
and ensure that there is enough room
for your Kube. Make sure the back of
the Kube isn't touching the back of
the cabinet; you'll need space for the
connections.
2
Shut Off the Water
Turn off your cold water at the inlet. Turn
on your faucet to make sure that the water
is completely off.
is usually on the right side.
Hot
TIP: The cold water valve
Cold
3
Disconnect Cold Water
Supply
Using a wrench, disconnect the cold water
supply line from the shutoff valve. Do
NOT disconnect the hot water!
a towel or paper towels under the sink to
collect any water that may run out of the
cold water line.
Hot
4
Connect the Adapters
Two adapters are provided in the Kube
Installation Kit. Thread the female adapter
onto the cold water shutoff valve, and
thread the male adapter onto the cold
water supply line, as shown. Hand tighten
each adapter.
Cold
TIP: Place
Cold