Using A Lap Belt Only - CYBEX gold ATON M + Manual Del Propietário

INSTALLING THE BASE USING A LAP BELT ONLY
BEFORE installing base, make sure vehicle is on
level ground. Place base on an approved vehicle
seating location.
MAKE SURE LATCH connectors are stored.
1
Unfold the Load Leg from underneath the Base.
2
Position Base on a rear vehicle seat. If a hump is
present on the floor of the vehicle, see page 35
for important information on the limits of using
the Load Leg in this seating position.
3
Adjust the Leveling Foot to achieve the correct
range for your child's weight as shown on the
Level Indicator. See page 39.
4
Fully open the Lock-off lifting it up.
Once open, the Lock-off will remain open on its
own.
48
3
4
2
1