CYBEX gold ATON M + Manual Del Propietário página 49

5
Route the lap belt through the vehicle belt
path opening on the side of the base and
under the Lock-off, then through the Belt
Guides on both sides of the base. BUCKLE
THE BELT. Remove slack from the lap belt and
make sure the belt lies flat and is not twisted.
The vehicle belt should ALWAYS be routed
UNDER the vehicle belt guide. NEVER place
a vehicle belt over Lock-off, even in a vehicle
with longer buckle stalks.
Make sure the vehicle lap belt is locked.
6
At this point, only remove slack from the
vehicle belt. The Lock-off will tighten the
system fully. If you have previously installed
the seat using LATCH, make sure the LATCH
Strap lies flat on the bottom of the Base. See
"To Store" section on page 33.
Lay the excess strap through the belt guides
under the Lock-off, so it's out of the way and
DOES NOT INTERFERE with the closing of the
Lock-off or the connection of the Infant Carrier
to the Base.
5
6
49