Extel JCH TOUCH SER.R1 Instrucciones De Uso E Instalación página 68

b. Positioning the dip-switches on the back of the monitors
IMPORTANT !
Any modifications of the position of the dip-switches on the back of the main monitor and on
the back of the additional monitor must be validated by the disconnection, during 30 seconds,
of the adapter.
Kit WEVP JCH TOUCH SER.R1
Monitor
Kit WEVP JCH TOUCH SER.R1
+ WEVPMS JCH TOUCH SER.R1
Moniteur
Moniteur supplémentaire
The distance between the 2 monitors is limited to 25m of cable (5 X 0.75 mm2)
IMPORTANT !
DO NOT LET THE MONITOR HANG FROM THE WIRES.
To facilitate the assembly of the grid you can carefully disconnect the 2 plugs coming from the
monitor. Without forgetting to put them back before hanging and screwing the support on the
monitor.
Do not disconnect the mini-connectors by pulling the wires but by releasing the body of the
connectors.
c. Connecting an electric strike or a lock
If an electrical lock or strike is added to the installation, connect it to the terminals
of the roadside panel.
IMPORTANT !
This function can only be used if the screen is switched on and by pressing shortly the key
and then release it (the screen switches off a few seconds and switches on again).
It is advisable to use an EXTEL strike or lock with call memory, it will remain unlocked after the
end of the electric pulse.
d. Connecting an automatic gate opener
Connect it directly to the terminals
supplies a current-free "dry" contact to connect to the "push button" control of your automatic gate
opener.
IMPORTANT !
This function can only be used if the screen is switched on and by pressing at least 2 seconds the
key and then release it (the screen switches off a few seconds and switches on again).
Dip-switch 1
ON (upward)
Dip-switch 1
ON (upward)
Off (downward)
on the back of the roadside panel. The roadside panel
8GB
Dip-switch 2
ON (upward)
Dip-switch 2
ON (upward)
Off (downward)
on the back