Electromagnetic Compatibility - Sophysa PRESSIO 2 PSO-4000 Manual De Instrucciones

Techni- Alarm Priori-
cal pa- condi- ty
rameter tion
ICT Average High
measure- ICT out-
ment side
range meas-
urement
range
NOTE
The DEACTIVATED ALARM status does not disable the
signals (visual and audible) of the technical alarms.
Disconnection of the Catheter disables the signals (vis-
ual and audible) of the technical alarms.
Operator position in terms of alarm readability: in front of the
®
Pressio 2 ICP Monitor screen.
Alarm condition delay
Physio- ICP ICT Fault in
logical the
parame- Cathe-
ter ter
pres-
sure
sensor
Average 8 s 1 s <1 s
alarm con-
dition de-
lay
Statistical 8 s 1 s <1 s
condition
statistical
delay
Average 0 s 0 s <1 s
alarm gen-
eration
delay

18. Electromagnetic Compatibility

WARNING
Use of the Monitor adjacent to or stacked with other
equipment should be avoided because it could result in
improper operation. If such use is necessary, the Moni-
tor and the other equipment should be observed to ver-
ify that they are operating normally.
Page 32 of 174
Re- Sound indica- Visual indi-
sponse tors cators
time
Prompt Three-pulse The mes-
sound, pause sage E005
for 300 ms, ALARM
two-pulse displays.
sound, pause
The display
for 500 ms,
area flash-
three-pulse
es red at a
sound, pause
frequency
for 300 ms,
of 2 Hz.
two-pulse
sound
The pulses are
separated by
100 ms
Sequence rep-
etition interval:
2.5 s
The pulse vol-
ume is 55 dB
Fault Cathe- Aver-
in the ter age
Cathe- cali- ICP
ter bra- out-
tem- tion side
pera- fault meas-
ture ure-
sensor ment
range
<1 s <1 min <1 s
<1 s <1 min <1 s
<1 s <1 min <1 s
Alarm condition delay
Physio-
logical
parame-
ter
Statistical
alarm gen-
eration
delay
Sum of
the
ALARM
SIGNAL
GENERA-
TION DE-
LAY and
average of
ALARM
CONDI-
TION DE-
LAY
Sum of
the
ALARM
SIGNAL
GENERA-
TION DE-
LAY and
distribu-
tion statis-
Aver-
tics of the
age
ALARM
ICT
CONDI-
out-
TION DE-
side
LAY
meas-
ure-
ment
Behavior of alarms following a power cut or powering off
range
<1 s
Power cut
≤ 30 s
Power cut
<1 s
> 30 s
Power cut
> 30 s
<1 s
Monitor
powered off
WARNING
Use of accessories, transducers and cables other than
those specified or provided by Sophysa could result in
increased electromagnetic emissions or decreased
electromagnetic immunity of this equipment and result
in improper operation.
ICP ICT Fault in Fault
the in the
Cathe- Cathe-
ter ter
pres- tem-
sure pera-
sensor ture
sensor
0 s 0 s <1 s <1 s
8 s 1 s <1 s <1 s
8 s 1 s <1 s <1 s
Battery status Alarm status
OK Conserved
OK Conserved
Flat Activated (by
default)
OK or flat Activated (by
default)
Cathe- Aver- Aver-
ter age age
cali- ICP ICT
bra- out- out-
tion side side
fault meas- meas-
ure- ure-
ment ment
range range
<1 min <1 s <1 s
<1 min <1 s <1 s
<1 min <1 s <1 s
Alarm thresholds
Conserved
Conserved
Conserved
Conserved