SATA AE5811 Manual Del Uso página 43

II. Anpassung
1.Riemeneinstellung
Die Art des Riemenantriebs muss nach30Stunden Betrieb der neuen Maschine überprüft werden.Wenn es zu locker ist, sollte es sofort
eingestellt werden und dann alle1500Stunden eingestellt werden.
Menge der
Verformung
Modell
10HP
15HP
20HP
1-1. As shown in the figure above, apply a load to the belt, and measure the deformation with a tensiometer. If the deformation exceeds the
standard value, adjust the tension of the belt.
1-2. If the belt is under tension, first loosen the four fixing screws of the motor base, then adjust the screws from the side to move the
motor. Finally, measure the tension with a tensiometer and then tighten the fixing screws of the motor.
1-3. To replace a belt, all belts must be replaced together instead of replacing only one belt, otherwise the tension on belt will be unequal.
1-4. Do not splash the oil on the pulley while adjusting or replacing the belt to prevent the belt from slipping.
AE5811/AE5812/AE5813
Last zum Zeitpunkt der ersten
Anpassung
(kg)
3
中文
EN
Tensiometer
Last
Load when it is adjusted after
30 hours of operation (kg)
2.5
DE RU KO PT JA ES
Menge der Verformung (mm)
8
7
43