SATA AE5811 Manual Del Uso página 48

Item
Compressor operates while
(8) being unloaded/heavily loaded
frequently
Oil found on the air filter when
(9)
the compressor is shut down
Abnormal noise from compressor
(10)
body
Other abnormal noise and
(11)
abnormal noise from V-bel
(12) Excessive vibration
Note: Power shall be switched off while the doors of compressor body are opened for maintenance to check that all air has been released
from the system; maintenance can be performed only when the compressor has been cooled down for 10 minutes.
48
AE5811/AE5812/AE5813
Fault description
1. Leakage in pipe
2. Too lower differential
pressure of pressure switch
3. Unstable air consumption
4. Capacity of selected air
cylinder too low
1. Intake valve not closed tightly
or stuck
2. Leakage in pressure retaining
valve
3. Relief valve not releases air
1. Foreign matter entering into
the compressor
2. Worn bearing
3. Belt is loose and creaks
4. Loud noise from the
unloaded compressor
1. Inappropriate installation of
air compressor
2. Loosen bolt or nut
3. Loosen V-belt
1. Improper installation
2. Loosen bolt or nut
中文
EN
Possible causes
1. Check and block where the leakage is
found.
2. Set it again
3. Increase the capacity of air reservoir
1. Overhaul it or contact our company if
necessary
2. Overhaul it or contact our company if
necessary
3. Overhaul it or contact our company if
necessary
1. Repair it to remove the foreign matters
2. Replace it
3. Adjusting belt
4. This noise is generated by the airflow, and
it does not affect the compressor operation.
1. Fill with cement, ensure the compressor is
installed on a level surface and secure the
compressor.
2. Tighten it.
3. Adjust it.
1. Fill with cement, ensure the compressor is
installed on a level surface and secure the
compressor.
2. Tighten it.
DE RU KO PT JA ES
Troubleshooting method