Reese M5 GM LEG Manual Del Usuario página 5

FOR INSTALLATION WITH M5
HEAD AND CENTER SECTION
7. Due to variations in truck underbed, it is normal for some handles to be loose and other handles to be too tight to lock. If a
handle appears too loose and rattles or cannot be closed fully, remove the cotter pin and adjust castle nut by hand to a position
where handle does not rattle and is able to close.
8. Once handle adjustment is satisfactory, re-insert cotter pin and bend end with pliers to hold in place. Additional cotter pins are
provided in the hardware kit for your convenience.
9. With GM Leg T-Pin handles locked and T-Pins securely held in under bed structure, tighten each M16 hex-head bolt to 220 ft-lb
of torque.
10. Verify that hitch is tight to truck bed by lifting each side of the hitch.
11. Assemble head to center section per instructions included with M5 Center Section and Head.
©
2017 Horizon Global America Inc.
Product Instructions
M5 GM LEG
Finger tighten castle nut only!
(Do not install cotter pin
until final adjustments
are made)
Page 5 of 21
30889N 10/25/2017
Part Number:
30889
Rev. A