Reese M5 GM LEG Manual Del Usuario página 6

FOR INSTALLATION WITH M5
HEAD AND CENTER SECTION
In order to maintain performance over the life of the product:
1. Before any trip, verify that cotter pins, foot bracket and castle nut are not damaged and are securely locked. Additionally
ensure that the lynch pins are also securely locked in place, with little to no vertical play. The image below shows the proper
orientation of the lynch pin in relation to the foot.
2. Every 1,000 miles, check the M16 hex bolts that connect center section to legs to insure that they are still torqued to 220 ft-lb
of torque.
3. For general maintenance of the entire 5
sheet.
Foot Bracket
©
2017 Horizon Global America Inc.
Product Instructions
M5 GM LEG
MAINTENANCE
th
wheel hitch assembly please refer to the M5 head and center section instruction
Lynch Pin
(Shown Open)
Cotter Pin
Lynch pin shown in properly closed position
Do not reverse loop to other side of pin
Page 6 of 21
Lynch Pin
(Shown Closed)
30889N 10/25/2017
Part Number:
30889
Rev. A