Vehicle Installation - Cequent Performance Products ROLA Pick-Up-Rack Manual Del Usuario

Please read all instructions carefully before assembly, installation and/or use of this product.
Assembly of Bed Mounts & Vertical Supports
1
Vertical Support
2

Vehicle Installation:

3
•
Clean bed rails.
•
Place Vertical Supports onto bed rail in desired location.
The long end of base must point towards the inside of
truck bed.
TIP: Mounting location is different for each bed design and
may require adjustment to avoid interference with
mounting hardware.
** Note: Some bed liners or bedrail covers may require alteration. It may be necessary to cut away a section of the liner on the underside
of the bedrail.
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Cover
M10-1.5 x 2" carriage bolt
M10 Lock washer
M10-1.5 Hex nut
(2) Places
Pick-Up-Rack™
Product Name:
Product Code:
plastic cap
•
Slide vertical support and cover into Support
Base.
•
Install two M10-1.5 x 2" long carriage bolts
through the two square holes in back of base
and through vertical support.
•
Install the M10 lock washers and hex nuts onto
carriage bolts.
•
Securely
¼-20 set screw
(approximately 25 Lb.-Ft. )
•
Slide cover into position and secure with
DO NOT over tighten.
•
Repeat steps for all four supports.
Support Base
•
Attach clamps and hand tighten.
•
Ensure both support bases are aligned front to
back on bed rail, both sides.
•
Leave clamps slightly loose at this step for ease
of crossbar alignment in steps 5 & 7.
Page 3 of 7
59742
•
Slide cover over vertical support as shown.
•
Insert plastic cap.
tighten all
¼-20 set screw using a 1/8" hex key wrench.
Wing nut
Clamp
M10-1.5 fasteners
59742N Rev G 4-19-16
Printed in China