Special Procedure - Mondolfo Ferro Startline S 524 Manual De Uso

- Inflate the tyre with the appropriate gun or by pressing
the pedal in an intermediate position (Fig. 34). Frequently
check the pressure on the pressure gauge to make sure
that the pressure NEVER exceeds the maximum pressure
indicated by the manufacturer on the tyre.
- Disconnect inflation hose from valve rod.
- Take the operating arms to the "non -" position.
- Remove the wheel from the tyre changer.
9.8.c. SPECIAL PROCEDURE (TI VERSION)
The TI version facilitates bead insertion and inflation of
Tubeless tyres through the emission of a strong jet of air
from the nozzles placed near the locking wedges.
Before starting with the operations described below, make sure there is no dirt, dust
or other impurities near the inflation nozzles. It is advisable to wear protective goggles.
- Verify that both upper and lower tyre beads and
rim bead seat have been properly lubricated with an
approved mounting paste.
- Move the horizontal arm to the wheel centre (all
slipped off towards the operator)
- Make sure that the wheel is clamped to the turntable
from the inner side (fig.35).
- Lower the vertical arm until it touches the rim (fig.31), then clamp the arm in this position.
- Remove the valve core if it has not already been removed (Fig. 32).
- Connect the Doyfe connector of the inflating hose to the valve stem (Fig. 33).
To increase the effectiveness of the air jets, manually lubricate and lift the lower
bead before activating the nozzles.
130
WARNING
WARNING
Startline S 424-S 421-S 521-S 524 Operator manual
33
34
35