Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Expose 2" (5 cm) of tape liner from each end of the flanges on the
3
Remove remaining tape liner by pulling on
5
OPTIONAL: Install (4) self tapping screws through the holes
on hood shield. A power screwdriver is recommended but
once the screw penetrates the inside metal panel use a
regular phillips screwdriver the remainder of the way.
7
Fender Protector
Installation
9
NOTE: Actual application may vary slightly from drawings.
hood shield.
free ends.
hood
hood shield
washer
screw
Do not overtighten
Clean mounting location above head-
lights and beside grill.
Align hood shield center point with center of hood. Press firmly to
adhere previously exposed tape to hood and verify position.
4
Press firmly along tape flanges to ensure
6
8
Expose 2" (5 cm) of tape liner from each end of the flanges on the
10
Page 2 of 3
proper adhesion.
Close hood.
fender protector.